22/07/2019
30
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
9.3. INITIAL STAR-UP
The electrical protection system must be tested before starting the appliance.
The machine must have been installed and/or inspected by qualified personnel. who will start up the machine
for the first time and provide the corresponding operating instructions.
Check that the wash and rinsing arms, the filters and the trays are correctly fitted and in place.
The electrical protection system must be tested before starting the appliance.
The machine must have been installed and/or inspected by qualified personnel. who will start up the machine
for the first time and provide the corresponding operating instructions.
Check that the wash and rinsing arms, the filters and the trays are correctly fitted and in place.
9.3.1. PREPARATION OF THE DISH
To correctly prepare the dishes to be washed, Fagor Industrial recommends you proceed as follows:
• Remove the largest pieces of waste food from the dishes before placing them in the baskets.
• Pre-wash the dishes/cutlery with jets of water and never with soapy water to remove waste such as olive
stones, toothpicks, grease, etc.
• First wash the glasses, then the cutlery and lastly the dishes.
• Insert the plates at an angle with the inner side of the plate facing upwards in the rack basket.
• Place wineglasses, cups and glasses upside down in the basket.
• Plan cutlery in the cutlery baskets, handles down, (different types of cutlery can be mixed), and place the
cutlery baskets in the base basket.
• Do not overload baskets.
• Dishes should be washed as soon as possible after use to prevent the dirt from drying on the plates.
9.3.2. PREPARATION AND SWITCHING ON THE MACHINE
To Next Page
Loading...
