22/07/2019
36
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
The diagnostics defined are listed below:
1. Door open: If DIP1=0 (Not top loading), Ip=0 (door open) and programme running (start or in middle): This
is indicated by a one-impulse train.
2. Filling error: If PT=1 (Tank not full) for 10 minutes, and V=1 (filling): This is indicated by a two-impulse train.
3. Drainage error: If PT=0 (Tank full) for 3 minutes, and BD=1 (draining): This is indicated by a three-impulse
train.
4. Boiler heating error. If PT=0 (Tank full) and TC=1 (boiler temperature not reached) for 35 minutes. This is
indicated by a four-impulse train. The error is reset when the machine is switched off.
5. Tank heating error: If Dip4=0: If TT=0 (tank temperature not reached) for 90 minutes and MBL=V=0 (Wash
pump motor stopped and without entering water): This is indicated by a five-impulse train. The error is
reset when the machine is switched off.
9.5. OPERATION OF THE CONCEPT PLUS
The wash cycle of the machine includes a wash, drainage and a final rinse.
The tank thermostat maintains the wash water temperature and a motor pump sends this water with detergent to
the washing arms. The jets of water reach the dishes from different directions in order to guarantee a uniform
wash.
Between the wash cycle and the rinse cycle there is a pause of a few seconds to allow the detergent to drain off the
dishes into the wash tub. If the machine has a drainage pump, part of the water is drained from the tank and
replaced by clean rinsing water.
Lastly, the dishes are rinsed with mains water heated to between 80 ºC - 85 ºC / 176 ºF - 185⁰F to remove the
detergent from the dishes and at the same time regenerate the water in the wash tank, making it less dirty.
If the machine does NOT have a Cycle SELECTOR switch ,just press the button corresponding to the required cycle
P1, P2, P3, insert the basket with the dishes in the machine and close the door. The Led L1, L2 or L3 corresponding
to the selected cycle flashes while the cycle is running. For the CONTINUOUS WASH cycle, press and hold P3 for
more than 3 seconds with the door closed; to stop the continuous wash cycle, press and hold P3 again for more
than 3 seconds with the door closed.
The cycle selected will remain selected until the selection is changed or the appliance is switched off.
Selecting the wash cycle:
55 - 65 ºC / 131 - 149 ⁰F
Boiler temp. 80 - 85 ºC / 176 - 185⁰F
The cycle should be selected according to the dirt on the dishes:
Short cycle (for dishes which are not very dirty).
Medium/standard cycle (for fairly dirty dishes).
Long cycle (for very dirty dishes or dishes with dried-on dirt).
PG (Program Glass): Glass wash cycle with rinse temperature of 65 ºC / 149 ºF.
9.5.1. THERMO-STOP
When the thermo-stop is activated, the wash cycle is extended, if necessary, until the boiler reaches a rinse
To Next Page
Loading...
