Fagor AD-505 - Electronic Control Cards, Viewers, Programmers, Regeneration Programmers, Electronic Regeneration Card and Backlight

22/07/2019
63
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
13.1. ELECTRONIC CONTROL CARDS, VIEWERS, PROGRAMMERS, REGENERATION
PROGRAMMERS, ELECTRONIC REGENERATION CARD AND BACKLIGHT
The models are identified by their baskets/hour production capacity. Previously the plates/hour capacity was
measured.
Essentially, we can say that:
- CONCEPT – Rinse using mains pressure (solenoid valve)
- CONCEPT PLUS – Rinse with pump and square boiler
- ADVANCE – Rinse with pump, square and electronic boiler
The digit for the “unit (XX?)” identifies the control type in the machine.
- CO-XX0 – Basic model.
- CO-XX1 – Basic model with certain extras with respect to the CO-XX0.model.
- CO-XX2 – Model with display and membrane.
- COP-XX4 – Model with display, membrane and rinse pump.
- AD-XX5 – Fully electronic model with rinse pump and air break.
The hardware is the same in the CO-XX0 and CO-XX1 models but the software is different.
The hardware is the same in the CO-XX2 and CO-XX4 models but the software is different.
The hardware and the software are specific for the AD-XX5 models.
There are two generations of EVO front-loading dishwashers:
- EVO 1.0 machine code up to 19047000
- EVO 2.0 machine code after 19047000
SPECIFICATIONS PLATE
1: NAME OF THE UNIT
2: CODE OF THE UNIT
3: SERIAL NUMBER + DATE OF
MANUFACTURE
4: ELECTRICAL SPECIFICATIONS
5: WATER SPECIFICATIONS
The following table shows the codes for the electronic cards and programmers in their different versions:
Front
Opening
Model
Card Display
Regeneration
(only SOFT)
BACKLIGHT
EVO 1.0 EVO 2.0 EVO 1.0 EVO 2.0
CO-500
12092150
(programmer)
12189021
12110837
CO-501
12092150
(programmer)
12189021
12110837