CNC 8035
·11·
DECLARATION OF CONFORMITY
The manufacturer:
Fagor Automation S. Coop.
Barrio de San Andrés Nº 19, C.P. 20500, Mondragón -Guipúzcoa- (SPAIN).
Declares:
Under their responsibility that the product:
8035 CNC
Consisting of the following modules and accessories:
8035-M, 8035-T
Note.
Some additional characters may follow the references mentioned above. They all comply with the directives
listed. However, check that that's the case by checking the label of the unit itself.
Referred to by this declaration with following directives:
As instructed by the European Community Directives 2006/95/EEC on Low Voltage and 2004/108/
EC on Electromagnetic Compatibility and its updates.
In Mondragón, July 27th, 2010.
Low voltage regulations.
EN 60204-1: 2006 Electrical equipment on machines — Part 1. General requirements.
Regulation on electromagnetic compatibility.
EN 61131-2: 2007 PLC — Part 2. Unit requirements and tests.
To Next Page
Loading...
