Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Parameters that may be modified from the OEM program or OEM
subroutine
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·76·
4.1 Parameters that may be modified from the OEM program
or OEM subroutine
Here is a list of the machine parameters that may be modified either from the oscilloscope or from
an OEM program/subroutine. The variables associated with the machine parameters must be used
to modify these parameters from an OEM program/subroutine. See "11.3 Variables associated
with machine parameters" on page 374.
General machine parameters:
Machine parameters of an axis:
Parameter Number Update
TLOOK P161 Beginning of program execution
CODISET P147 Immediate
Parameter Number Update
BACKLASH P14 Immediate
ACCTIME P18 Beginning of the next block
INPOSW P19 Immediate
MAXFLWE1 P21 Immediate
MAXFLWE2 P22 Immediate
PROGAIN P23 Immediate
DERGAIN P24 Immediate
FFGAIN P25 Immediate
BAKANOUT P29 Immediate
BAKTIME P30 Immediate
REFDIREC P33 Immediate
REFVALUE P36 Immediate
MAXVOLT P37 Immediate
G00FEED P38 Beginning of the next block
MAXFEED P42 Beginning of the next block
JOGFEED P43 Beginning of the next block
ACCTIME2 P59 Beginning of the next block
PROGAIN2 P60 Immediate
DERGAIN2 P61 Immediate
FFGAIN2 P62 Immediate
JERKLIM P67 Beginning of the next block
FLIMIT P75 Beginning of the next block
TORQDIST P78 Immediate
PRELOAD P79 Immediate
TPROGAIN P81 Immediate
TINTTIME P82 Immediate
TCOMPLIM P83 Immediate