Fagor CNC 8035 - Page 77

 Installation manual
CNC 8035
MACHINE PARAMETERS
Parameters that may be modified from the OEM program or OEM
subroutine
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·77·
Spindle machine parameters:
A modification in the MAXGEAR(1··4) parameters sets the square corner mode even if a round
corner has been programmed.
Parameter Number Update
MAXGEAR1 P2 Beginning of the next block
MAXGEAR2 P3 Beginning of the next block
MAXGEAR3 P4 Beginning of the next block
MAXGEAR4 P5 Beginning of the next block
ACCTIME P18 Beginning of the next block
INPOSW P19 Immediate
PROGAIN P23 Immediate
DERGAIN P24 Immediate
FFGAIN P25 Immediate
REFDIREC P33 Immediate
REFVALUE P36 Immediate
MAXVOLT1 P37 Immediate
MAXVOLT2 P38 Immediate
MAXVOLT3 P39 Immediate
MAXVOLT4 P40 Immediate
OPLACETI P45 Immediate
ACCTIME2 P47 Beginning of the next block
PROGAIN2 P48 Immediate
DERGAIN2 P49 Immediate
FFGAIN2 P50 Immediate
SLIMIT P66 Immediate
JERKLIM P80 Beginning of the next block