CNC 8035
·13·
VERSION HISTORY (M)
(mill model)
Here is a list of the features added in each software version and the manuals that describe them.
The version history uses the following abbreviations:
INST Installation manual
PRG Programming manual
OPT Operating manual
Software V07.1x July 2003
First version.
Software V09.0x February 2004
List of features Manual
Incline axis. INST / PRG
Machine parameters.
TOOLTYPE (P167): Stop block preparation when executing a new "T".
TOOLTYPE (P167): Execute the stop signal when done with the "T" change.
FEEDTYPE (P169): Select the behavior of the feedrate for F0.
TYPCROSS (P135): On Gantry axes, cross compensation is also applied to the slave axis.
RAPIDEN (P130): Rapid key controlled by PLC.
General parameters that may be modified from OEM subroutine/program: CODISET.
Axis parameters that may be modified from OEM subroutine/program: MAXFLWE1,
MAXFLWE2.
INST
PLC marks.
Name the logic inputs and outputs with the axis name
BLOABOR: Ending the execution of a block using a PLC mark (main channel).
BLOABORP: Ending the execution of a block using a PLC mark (PLC channel).
ELIMIS: Park the spindle.
INST
While compiling the PLC program, the outputs are initialized to zero.
Variables.
SELPRO: Variable to select the active probe input.
DIAM: Variable to select the programming mode, radius or diameter.
INST / PRG
G2/G3. There is no need to program the center coordinates if their value is zero. PRG
M41-M44: These functions admit subroutines when the gear change is automatic. PRG
To Next Page
Loading...
Need help?
General
