Fagor CNC 8035 - Page 133

 Installation manual
CNC 8035
MACHINE PARAMETERS
Axis parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·133·
SWITCHAX (P65)
When having 2 axes controlled by a single servo drive, machine parameter SWITCHAX of the
secondary axis indicates which one is the main axis it is associated with.
Example:
On a machine where the X and Z axes cannot move at the same time, the X axis is the main axis
and the Z axis is the secondary (associated with the X axis).
SWITCHAX for X = 0.
SWITCHAX for Z = 1.
SWINBACK (P66)
When having 2 axes controlled by a single servo drive, machine parameter SWINBACK of the
secondary axis indicates whether it has its own feedback device or it uses that of the main axis it
is associated with.
Value Meaning Value Meaning
0 None. 6 With the W axis.
1 With the X axis. 7 With the A axis.
2 With the Y axis. 8 With the B axis.
3 With the Z axis. 9 With the C axis.
4 With the U axis. 10 Spindle.
5 With the V axis.
Default value: 0
Value Meaning
0 It assumes the feedback of the main axis.
1 It has its own feedback device.
Default value: 0