Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Axis parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·138·
FLIMIT (P75)
Maximum safety limit for the axis feedrate. This limit is activated from the PLC and is applied to all
the work modes, including the PLC channel.
This limit is activated for all the axes using the mark FLIMITAC (M5058). When the limit is canceled,
the CNC recovers the programmed feedrate.
This limit permits clearing the axis feedrate temporarily via PLC, e.g. when opening the doors, etc.
TANSLAID (P76) TANSLANA (P77) TORQDIST (P78)
PRELOAD (P79) PRELFITI (P80) TPROGAIN (P81)
TINTTIME (P82) TCOMPLIM (P83)
Not being used.
ADIFEED (P84)
Maximum feedrate allowed, due to the additive handwheel.
FRAPIDEN (P85)
Maximum axis feedrate when activating the EXRAPID mark and when pressing the rapid key in
execution or in simulation with motion.
If set to 0, it assumes the feedrate set by parameter G00FEED. If it is set with a value higher than
G00FEED, the feedrate will be limited to G00FEED.
This limit does not affect the rapid jog which will still have the value of parameter G00FEED.
Calculation example for a particular response of the machine.
Possible values
Between 0 and 99999.9999 degrees/min or mm/min.
Between 0 inches/min and 3937.00787 inches/min.
Default value: 0
Possible values
Between 0 and 99999.9999 degrees/min or mm/min.
Between 0 inches/min and 3937.00787 inches/min.
Default value: 1000
Possible values
Between 0 and 199999.9999 degrees/min or mm/min.
Between 0 and 7874.01574 inches/min.
Default value: 0
To Next Page
Loading...
