Installation manual
CNC 8035
CONCEPTS
Jog
5.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·189·
Considerations about the jog movements
This mode assumes as axis feedrate the one selected in jog mode and it will also be affected by
the feedrate override switch. If F0 is selected, it assumes the one indicated by machine parameter
"JOGFEED (P43)". This mode ignores the rapid jog key.
"PATH JOG" movements respect the travel limits and the work zones.
"Path jog" movements may be aborted in the following ways:
• By pressing the [STOP] key.
• By turning the JOG switch to one of the handwheel positions.
• By setting general logic input "MASTRHND (M5054)" = 0.
• By setting general logic input "\STOP (M5001)" = 0.
To Next Page
Loading...
