Fagor CNC 8035 - Page 42

 Installation manual
CNC 8035
1.
CNC CONFIGURATION
CNC structure
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·42·
Work levels for sinusoidal signal (only for axes).
Maximum frequency: 500 kHz
Feedback input for the handwheels
Power supply consumption of +5 V 1 A (250 mA per axis).
Work levels for differential square signal.
Work levels for non-differential square signal.
A and B signals Amplitude: 0.6 ÷ 1.2 Vpp
Centered: |V1-V2| / 2 Vpp =< 6.5%
Relationship: VApp / VBpp = 0.8 ÷ 1.25
Phase shift: 90º ± 10º
Reference mark (I0) Amplitude: 0.2 ÷ 0.85 V
Width: T-90º =< I0 =< T+180º
Maximum frequency: 200 kHz.
Maximum gap between flanks: 460 ns.
Phase shift: 90º ± 20º.
Vmax in common mode: ± 7 V.
Vmax in differential mode: ± 6 V.
Hysteresis: 0,2 V.
Maximum differential input current: 3 mA.
Maximum frequency: 200 kHz.
Maximum gap between flanks: 460 ns.
Phase shift: 90º ± 20º.
High threshold (logic level "1") V
IH
: 1.25 V < V
IH
< 7 V.
Low threshold (logic level "0") V
IL
:-7 V < V
IL
< 1 V.
Vmax: ± 7 V.
Hysteresis: 0,25 V.
Maximum differential input current: 3 mA.