Fagor CNC 8035 - Page 435

 Installation manual
CNC 8035
APPENDIX
Summary of internal CNC variables.
C.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·435·
LONGAX R R R Axis affected by the tool length compensation (G15).
MIRROR R R R Active mirror images.
SCALE R R R General scaling factor applied. Reading from the PLC in ten-thousandths.
SCALE(X-C) R R R Scaling Factor applied only to the indicated axis. Reading from the PLC in
ten-thousandths.
ORGROT R R R Rotation angle (G73) of the coordinate system.
ROTPF R - - Abscissa of rotation center.
ROTPS R - - Ordinate of rotation center.
PRBST R R R Returns probe status.
CLOCK R R R System clock in seconds.
TIME R R R/W Time in Hours, minutes and seconds.
DATE R R R/W Date in Year-Month-Day format
TIMER R/W R/W R/W Clock activated by PLC, in seconds.
CYTIME R R R Time to execute a part in hundredths of a second.
PARTC R/W R/W R/W Parts counter of the CNC.
FIRST R R R First time a program is executed.
KEY R/W R/W R/W keystroke code.
KEYSRC R/W R/W R/W Source of the keys.
ANAIn R R R Voltage (in volts) of the indicated analog input (n).
ANAOn R/W R/W R/W Voltage (in volts) to apply to the indicated output (n).
CNCERR - R R Active CNC error number.
PLCERR - - R Active PLC error number.
DNCERR - R - Number of the error generated during DNC communications.
DNCSTA - R - DNC transmission status.
TIMEG R R R Remaining time to finish the dwell block (in hundredths of a second).
SELPRO R/W R/W R When having two probe inputs, it selects the active input.
DIAM R/W R/W R It changes the programming mode for X axis coordinates between radius
and diameter.
PRBMOD R/W R/W R Indicates whether a probing error must be displayed or not.
RETREJ R/W R/W R It indicates that the retraction in drilling, or the mill type threading or lathe
type threading has finished.
RIP R R R Linear theoretical feedrate resulting from the next loop (in mm/min).
RIGIER R R R Offset between the projection of the following error of the spindle onto the
longitudinal axis and the following error of the longitudinal axis.
Variable CNC PLC DNC
( section 11.12 )
The "KEY" variable can be "written" at the CNC only via the user channel.
The "NBTOOL" variable can only be used within the tool change subroutine.