Installation manual
CNC 8035
E.
APPENDIX
Summary of PLC inputs and outputs
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·444·
AXIS LOGIC OUTPUTS.
SPINDLE LOGIC OUTPUTS.
MSTROBE M5532 Indicates that the auxiliary M functions which are indicated in registers R550 to R556
must be executed.
SSTROBE M5533 Indicates that the auxiliary S function of register R557 must be executed.
TSTROBE M5534 Indicates that the auxiliary T function of register R558 must be executed.
T2STROBE M5535 Indicates that the auxiliary T function of register R559 must be executed.
ADVINPOS M5537 For punch presses, it indicates that punching may begin.
INTEREND M5538 It indicates that the interpolation is finished.
INPOS M5539 The axes are in position.
DM00 M5547 Program interrupted after executing the auxiliary function M00.
DM01 M5546 Program interrupted after executing the auxiliary function M01.
DM02 M5545 The execution of the program has stopped after executing the auxiliary M02 function.
DM03 M5544 The spindle is turning clockwise (M03).
DM04 M5543 The spindle is turning counterclockwise (M04).
DM05 M5542 The spindle is stopped (M05).
DM06 M5541 The auxiliary M06 function has been executed.
DM08 M5540 The coolant output has been activated (M08).
DM09 M5555 The coolant output has been canceled (M09).
DM19 M5554 A block with spindle stop has been executed (M19).
DM30 M5553 The program concluded after executing the auxiliary M30 function.
DM41 M5552 First spindle speed gear (range) selected (M41).
DM42 M5551 Second spindle speed gear (range) selected (M42).
DM43 M5550 Third spindle speed gear (range) selected (M43).
DM44 M5549 Fourth spindle speed gear (range) selected (M44).
RETRACT M5567 It indicates that the drilling stop or the mill type threading stop or the retraction in a
lathe type threading has finished.
Axis 1 Axis 2 Axis 3
ENABLE* M5600 M5650 M5700 Enables axis movement.
DIR* M5601 M5651 M5701 Indicate axis moving direction.
REFPOIN* M5602 M5652 M5702 Home search done.
DRSTAF* M5603 M5653 M5703 With CAN. They indicate servo drive status.
DRSTAS* M5604 M5654 M5704 With CAN. They indicate servo drive status.
ANT* M5606 M5656 M5706 If distance < MINMOVE (P54), ANT*=1
INPOS* M5607 M5657 M5707 Axis in position.
Main
ENABLES M5950 Enables spindle movement.
DIRS M5951 Spindle turning direction
REFPOINS M5952 The spindle has been already referenced (homed).
DRSTAFS M5953 With CAN. They indicate servo drive status.
DRSTASS M5954 With CAN. They indicate servo drive status.
REVOK M5956 Spindle rpm correspond to programmed speed.
INPOSS M5957 Spindle in position.
To Next Page
Loading...
