Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·88·
TRMULT (P62) TRPROG (P63) TRDERG (P64)
MAXDEFLE (P65) MINDEFLE (P66) TRFBAKAL (P67)
Not being used.
TIPDPLY (P68)
Indicates whether the CNC displays the position of the tool tip or that of the tool base when working
with tool length compensation.
On the Mill model, it is necessary to execute G43 in order to work with tool length compensation.
When not working with tool length compensation (G44), the CNC displays the tool base position.
On the Lathe model, it always works with tool length compensation. Therefore, by default, the CNC
always displays the tool tip position.
ANTIME (P69)
It is used on punch presses that have an eccentric cam as a punching system.
It indicates how far in advance the general logic output ADVINPOS (M5537) is activated before the
axes reach position.
This reduces idle time, thus increasing the number of punches per minute.
If the total duration of the movement is lower than the value in parameter ANTIME, the anticipation
signal (ADVINPOS) will be activated immediately.
If ANTIME = 0, the anticipation signal ADVINPOS will never be activated.
PERCAX (P70)
Not being used.
TAFTERS (P71)
g.m.p. TOOLSUB (P60) indicates the number of the subroutine associated with the tool.
The TAFTERS parameter determines whether the tool selection is carried out before or after
executing that subroutine.
Value Meaning
0 It displays the coordinate of the tool base.
1 It displays the coordinate of the tool tip.
Default value: 0 (for the M model)
Default value: 1 (for the T model)
Possible values
Integers between 0 and 65535 ms.
Default value: 0
Value Meaning
YES After executing the subroutine.
NO Before executing the subroutine.
Default value: NO
To Next Page
Loading...
