Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·91·
(hundreds) Activate the compensation in the first motion block.
The hundreds indicate whether the compensation is activated in the first motion block or not, even
if the plane axes are not involved. The same criteria also applies when turning the compensation off.
After activating the compensation, it could happen that the plane axes do not get involved in the first
motion block either because they have not been programmed or because the same point as the tool
position has been programmed or because a null incremental move has been programmed. In this
case, the compensation is applied in the current tool position; depending on the first movement
programmed in the plane, the tool moves perpendicular to the path on its starting point.
The first movement programmed in the plane may be either linear or circular.
FPRMAN (P75)
It is only used on lathe model CNC's and it indicates whether feedrate per revolution is permitted
or not.
MPGAXIS (P76)
It is only used on the Lathe model CNCs and it indicates which axis the handwheel is assigned to.
It is set according to the following codes:
Value Meaning
0xx The compensation is activated in the first block having a movement of the
plane axes.
1xx The compensation is activated in the first motion block even if there is no
movement of the plane axes.
Default value: 000
· · ·
G90
G01 Y40
G91 G40 Y0 Z10
G02 X20 Y20 I20 J0
· · ·
(X0 Y0)
Y
X
· · ·
G90
G01 X-30 Y30
G01 G41 X-30 Y30 Z10
G01 X25
· · ·
(X0 Y0)
Y
X
Example of beginning of compensation (COMPTYPE=1x1)
Value Meaning
YES Admitted.
NO Not admitted.
Default value: NO
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9 "C" axis.
Default value: 0 (shared)
To Next Page
Loading...
