Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·98·
PROBERR (P119)
Indicates whether the CNC issues an error message when the axes reach the programmed position
without having received the probe signal while executing function G75 or G76.
SERSPEED (P120) SERPOWSE (P121)
Not being used.
LANGUAGE (P122)
Defines the work language.
GEOMTYPE (P123)
It indicates whether the cutter geometry is associated with the tool (T) or with the tool offset (D).
The "T" function, tool number, indicates the magazine position it occupies.
The "D" function, offset, indicates the tool dimensions.
When using a tool holding turret, the same turret position is usually used by several tools. In those
cases, the "T" function refers to the turret position and the "D" function to the dimensions and
geometry of the tool occupying that position. Thus, "GEOMTYPE=1".
SPOSTYPE (P124) AUXSTYPE (P125)
Not being used.
FOVRG75 (P126)
It indicates whether function G75 ignores the feedrate override switch of the front panel or not.
Value Meaning
YES It issues the error message.
NO It does NOT issue the error message.
Default value: NO
Value Meaning Value Meaning
0 English 7Czech
1 Spanish 8 Polish
2French 9 Mainland Chinese
3 Italian 10 Basque
4German 11 Russian
5Dutch 12 Turkish
6 Portuguese
Default value: 0
Value Meaning
0 It is associated with the tool.
1 It is associated with the tool offset.
Default value: 0
Value Meaning
NO It ignores the setting of the switch. Always at 100%.
YES It is affected by the % of the switch.
Default value: NO
To Next Page
Loading...
