Fantic ENDURO PERFORMANCE 2020 - Page 96

96
ENGLISH
ADJUSTMENT
- Adjust the screw (1) located on the carburettor
(left side).
- TIGHTENING (clockwise), the revs increase.
- LOOSENING (counter-clockwise), the revs de-
crease.
To check correct operation and if the idling speed
remains stable, twist the accelerator handle to ac-
celerate and throttle down a few times.
NOTE: do not adjust the air adjusting screw to
avoid altering the mixture settings.
If necessary, consult a Dealer.
ADJUSTMENT
- Place the vehicle on the stand.
- Remove the protective sleeve.
- Loosen the ring nut (2).
- Turn the adjusting device (3) to reset the recom-
mended value.
After having completed adjustment, check that the
engine idle speed does not change upon turning
the handlebar and that when the accelerator han-
dle is released it returns automatically to the rest
position.
THROTTLE CONTROL
For the maintenance intervals, see (PERIODIC
MAINTENANCE CHARTS), under:
- Throttle control.
CHECK
The no-load travel (A) of the accelerator handle
must be 2-3 mm, measured on the rim of the
actual twist grip handle.
ADJUSTMENT
- Place the vehicle on the stand.
- Remove the protective sleeve.
- Loosen the ring nut (2).
- Turn the adjusting device (3) to reset the recom-
mended value.