86
ENGLISH
BRAKES
BRAKE FLUID
The brake fl uid is:
- harmful by inhalation, if swallowed or in contact
with skin, with possible serious consequences;
- irritating to skin;
- harmful to the soil and aquatic environment,
harmful to fl ora and fauna.
To be avoided:
- contact with skin;
- inhalation of vapours;
- ingestion;
- release to the environment;
- exposure to air.
If swallowed do NOT induce vomiting but seek
medical advice immediately (fi rst aid post), indi-
cating the cause and how the accident occurred.
After contact with skin, wash the affected part im-
mediately with soap and water, repeating the oper-
ation until completely clean.
In case of contact with eyes or ears, rinse the affect-
ed parts immediately with plenty of water and seek
medical advice immediately (fi rst aid post), indi-
cating the cause and how the accident occurred.
After contact with clothes, remove contaminated
articles and wash immediately with plenty of water
and soap. Change the dirty clothes, which must be
washed as soon as possible.
If brake fl uid is accidentally spilt, clean the affected
area thoroughly.
Always wear latex gloves to protect hands when
carrying out maintenance.
Always close the brake fl uid cover well after every
fi lling up.
KEEP OUT OF REACH OF CHILDREN. DISPOSE OF
THE BRAKE FLUID AT A SPECIAL WASTE COLLEC-
TION POINT.
The used brake fl uid must be put in a sealed con-
tainer and taken to the nearest service station or
to a waste oil collection point where it will be dis-
posed of correctly.
DISK BRAKES
The brakes are a fundamental part for vehicle safe-
ty. Always keep them fully effi cient. Check them for
wear prior to setting off on any journey.
A decrease in braking power could be caused by
water depositing on the disks and on the brake
pads and it is therefore recommended that the
vehicle be dried thoroughly after washing. If trav-
elling on wet roads, proceed with caution and con-
tinuously try out the brakes.
Mixer oil reservoir capacity (reserve included) and
reservoir reserve: see (SPECIFICATIONS) under
FUEL.
Mixer oil reservoir reserve: see (SPECIFICATIONS)
under FUEL.
Procedure for topping up the Auto-mix oil:
Unscrew and remove the mixer oil reservoir fi ller
cap (1) on the left side of the fuel tank.
1
Do not add additives or other substances to the
fuel. If a funnel or such is used, make sure that it
is perfectly clean. When topping up, do not exceed
the “fi ll level”. Make sure that the cap is perfectly
closed.
To Next Page
Loading...
