Faraday MPC-6000

To Next Page

To Previous Page

MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL

Following is an example of the Events Output on a HyperTerminal connection.

Figure 3

Events Output when HyperTerminal is Connected

Figure 4

Sensitivity Report on HyperTerminal

(Refer to Programming Manual to access this feature)

Main Page

Default Chapter3
- Table of Contents3
Introduction7
- Control Unit Limitations7
- Installation and Warranty Information8
  - Installer Information8
  - Original Purchaser Information8
- Preface9
- Mpc-6000 System Description10
- Mpc-7000 System Description12
- Rnd-2 System Description14
- Optional Modules16
- Auxiliary Modules19
- X1 Addressable Devices20
- Event History21
- General Design Features22
- Regulatory Standards23
  - Federal Communications Commission23
  - Underwriters Laboratories23
- General Specifications24
Control Unit Operation28
- Operation Instructions28
- Additional Operating Procedures32
- Mpc-6000 / Mpc-7000 / Rnd-2 Operating Instructions34
- Rdc-2 / Rdc-3 Operating Instructions35
- Mpc-6000 / Rdc-3 with Releasing Operating Instructions36
Control Unit Installation37
- Parts Supplied - Mpc-6000 / Mpc-7000 / Rnd-237
- Caution38
- Control Unit Location38
- Installation38
- Enclosure Mounting38
System Wiring47
- AC Supply Connection47
- Battery Installation48
- Powering the Control Unit48
- Optional Modules48
- Check System Operation48
- Wiring48
Programming the Control Unit60
- Keypad Programming60
- Pc Programming60
- Programming Security60
- Maintenance61
- Quick Test62
Appendix-A: Reference Data65
- Wire Selection Guides65
- Battery Size Calculations67
Appendix-B: Compatible Devices70
- Devices for Addressable Device Circuits70
- Devices for Notification Appliance Circuits72
- Devices for Auxiliary Power Outputs72
  - Relays72
Appendix-C: Troubleshooting73
- Definitions for Event History Entries73
Appendix-D: Module Installation Instructions List77
Appendix-E: Alarm Verification78
Appendix-F: Application Specific Detection79
Appendix-G: Testing/Maintenance80
Appendix-H: Lcd, Controls and Indicators81
- Communication Port Connector81
- LEDS, Sounder and Dedicated Push Buttons81
- Alphanumeric Keypad82
- LCD Display82
Appendix-I: Output Features84
Appendix-J: Pas/Pre-Signal86
Appendix-K: Diagnostics Leds88
Appendix-L: Dact Information Overview89
Appendix-M: Network Overview93
Appendix-N: Diagnostic Printer96
Appendix-O: Glossary102

Faraday MPC-6000 - Page 98

Table of Contents

Other manuals for Faraday MPC-6000

Related product manuals