DAZZLER
TM
system manual Part I : installation & operation 5.5
Lowjitter, sequence and most options implemented.
This file is created by Fastlite and should never be changed. Otherwise, the generator and
software might stop working completely.
DazCurrent.txt
This file contains the parameters optionally saved upon exit by the software to be kept for the
next execution. Hence this file is only written if the user answers ”yes” when asked ”Do you
want to save the current settings for next restart?”.
This file also contains different sections, the main one being [Trig&Mode ], which contains all
the parameters of the Trig&Mode panel.
Though being marked rw, this file should rarely have to be changed by hand. Parameters
should be changed during the software execution, and saved upon exit.
wave.txt
This file keeps the main panel control values for re-use on the next start. Users wishing to
operate the remote control options will use this file to find the names and syntax of the various
check boxes, knobs and controls (see chapter 6).
If the waveform was programmed using
7
the files ”AMP.txt” or ”PHASE.TXT”, the contents of
these two files are stored in ”wave.txt” in sections #AMP and/or #PHASE. When the waveform
parameters are restored, the contents of the files ”AMP.TXT” or ”PHASE.TXT” are overwritten
back to what they were when the waveform was saved.
The same principle applies for the waveforms using combinations between multiple buffers.
Each of them is saved and restored when reading the wave file (section name: #mem0).
The trigger settings are also stored in the ”wave.txt”, but are only here as a reminder. Trigger
settings are NOT modified when the waveform parameters are restored.
Other Files
Some other files may be found among other parameter files. They can be divided into three
different types:
• calibration files,
• files for Dazzler
TM
system options,
• copies of the last used configuration.
Files for Dazzler
TM
system options
Data files that are required for some of the Dazzler
TM
options. They are read and written by
the application program.
rw lowjitter.txt data for Low jitter option
rw cepcalib.txt calibration data for CEP option
7
when either the control Amplitude or Phase having value file(1) or both(2)
V3.00 - 8
th
April 2019 (ContentsTable) (FiguresTable) 51/94
To Next Page
Loading...