Partie II – Starting the pump
22
Inserting the battery
Before using the SO
♥
CONNECT PID pump for the first time, you need to charge the battery.
The cover of the battery compartment holds the battery in position. Slide the cover by hand to remove it and put it back.
Precautions
▪
Do not use a knife, screwdriver or other pointed object to remove the battery compartment cover, as that could damage the
SO
♥
CONNECT PID
pump.
▪
In order to keep water out of the
SO
♥
CONNECT PID
pump housing, install or replace the battery in a dry place.
▪
Make sure that the battery compartment cover is not damaged or missing and that the battery has been installed correctly.
▪
Take care to insert the battery in the right direction. Inserting the battery in the wrong direction could damage the
SO
♥
CONNECT
PID
pump.
1) Slide the battery compartment cover from right to left until it comes completely out of the
groove.
2) Insert the battery in the compartment of the SO
♥
CONNECT PID pump. Take care to insert
the battery the right way: the + end of the battery must be at the + terminal of the pump, and
likewise for the – end.
The battery's label should be facing downwards, towards the bottom of the battery
compartment.
3) Insert the battery compartment cover back in the groove. And slide the cover back into place,
from left to right.
To Next Page
Loading...