EasyManua.ls Logo

FDE SO-CONNECT PID - Description of the Pump

Default Icon
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Partie I Description of pump and accessories
9
Description of the pump
The SO
CONNECT PID pump is an ambulatory infusion pump that is intended for the controlled subcutaneous administration of :
SCIg as part of the treatment of PIDs (Primary Immunodeficiency Disorders). It uses 20 ml, 30 ml or 50 ml SO
FILL sterile single-use
reservoirs.
DESFERAL in the treatment of primary haemochromatosis not curable by bleeding, hemosiderosis.
Those SO
FILL reservoirs have been designed especially for use with the SO
CONNECT PID pump.
The SO
CONNECT PID pump has been designed for use by healthcare professionals in a clinical environment and by ambulatory users
(patients and healthcare professionals) in patients’ homes.
The features of the SO
CONNECT PID pump have been designed to make treatment easier and keep the patient safe.
Screen with resistive touch panel
The SO
CONNECT PID pump has a screen with a resistive touch panel that makes configuration and infusion control easier.
Programming the infusion rate or duration of the infusion
The infusion rate can be set from 0 to 60 ml/h in increments of 0.1 ml.
Facility to adjust the infusion rate during infusion
The SO
CONNECT PID pump makes it possible to adjust the infusion rate during infusion.
Saving of infusion settings
The settings of the last infusion are saved automatically even if the battery is changed. They can be used to start an infusion rapidly.
Locking of setup and configuration functions
The SO
CONNECT PID pump setup and the settings of an infusion are only accessible after entering a password.
Infusion precision
The feed mechanism (pusher) of the SO
CONNECT PID pump directly controls the plunger of the SO
FILL reservoir, which makes
for very precise administration of the medication. The SO
CONNECT PID pump administers a dose dependent on the set infusion
rate every 18 seconds.
Bluetooth Low Energy connection
A Bluetooth Low Energy connection is used to export the clinical data and control the infusion with a remote control.

Table of Contents