Partie VII – Entretien, maintenance, élimination, garantie
63
Pump coming in contact with water
Precautions
▪
The
SO
♥
CONNECT PID
pump is not sealed. Use the case supplied with your pump to protect it from accidental splashing with
water.
▪
Avoid all contact with water. Remember to disconnect and remove it before you have a bath or a shower, enter a Jacuzzi or go
swimming.
▪
Avoid excess humidity (e.g. sauna), which could damage the
SO
♥
CONNECT PID
pump.
If your SO
♥
CONNECT PID pump comes in contact with water, please follow the instructions below:
▪ Pause the infusion, disconnect the SO
♥
CONNECT PID pump and inspect it.
▪ Wipe the outside of the pump with a soft, dry cloth and check to see if any water has entered the battery compartment or the
compartment of the SO
♥
FILL syringe. If the battery or SO
♥
FILL syringe compartment is wet, turn the SO
♥
CONNECT PID pump
over to let the water drain out, and leave it to dry.
▪ Do not use hot air to dry the SO
♥
CONNECT PID pump. For example, do not use a hair dryer. That could damage the pump housing.
▪ Do not put back the battery or the SO
♥
FILL syringe before the compartments are fully dry.
It is crucial to verify the pump immediately if it comes in contact with other liquids or chemicals, such as:
▪ cleaners,
▪ alcohol,
▪ beverages,
▪ oil or grease.
Clean your pump immediately if it has come into contact with such materials.
Precautions
▪
Avoid putting the
SO
♥
CONNECT PID
pump in contact with medicines or hygiene products (e.g. antiseptic, antibiotic cream, soap,
scent, deodorant, body lotion or any other cosmetics). Such substances could discolour the
SO
♥
CONNECT PID
pump or damage
the screen.
To Next Page
Loading...