Revised 09.15.11 Proteus A3/125 Technical Service Manual
6
Tools
Screwdrivers Phillips screwdrivers
Flathead screwdrivers
Pliers Long nose pliers
E-clip pliers
Wrenches/Sockets Allen wrenches
Socket wrenches
Nut drivers
Gauges Roller pressure gauge
Housing Assemblies
The laminator housing consists of the top housing cover and a
bottom metal plate. The housing cover holds the operator control
panel, power switch, and cord socket. The bottom plate holds all
the mechanical and electrical assemblies and has four rubber feet
attached to prevent the laminator from moving.
This section has procedures to:
Remove Housing Cover
Remove Rubber Foot
Replace Control PCB
PC Board and
Keypad
Housing
Cover
Bottom Metal
Plate
To Next Page
Loading...
