Fellowes Proteus A3/125 - Remove Housing Cover; Remove Rubber Foot

Proteus A3/125 Technical Service Manual Revised 09.15.11
7
Remove Housing Cover
1 Remove the 4 screws that hold the housing cover to the
base.
2 Carefully lift and turn the housing cover on its side.
3 Disconnect the cable from the Control Panel PCB.
Remove Rubber Foot
1 Turn the laminator over and place it face-down on a soft
surface to avoid damaging the cover housing
2 Remove the screw in the center of the rubber foot.
3 Replace foot and secure it with the screw.
DO THIS FIRST
Unplug the Laminator
TOOLS
Phillips screwdriver
TOOLS
Phillips screwdriver