2. Safety instructions for electric drives and controllers
16 Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH
Warning
Gold contacts or contacts with high contact pressure should be
used to connect the control contacts.
Precautionary measures must be taken to prevent interference to
switching systems, e.g. Connecting protective switches and relays
with RC elements or diodes.
You must observe the safety regulations and directives of the
country in which the device is to be used.
Warning
• The environmental conditions specified in the product
documentation must be observed.
Safety-critical applications are not permitted if unless explicitly
approved by the manufacturer.
• See Chapter 6.5 Instructions on safe and EMC-compliant
installation (Page 114) for the instructions for EMC-compliant
installation.
The manufacturer of the system or machine is responsible for
ensuring that the limit values required by the national regulations
are observed.
Warning
See this product manual for the specifications, connection and
installation conditions for the stepping motor controller and
absolutely must be observed.
Warning
DANGER!
• The general installation and safety regulations for working on
high-current systems (e.g. DIN, VDE, EN, IEC or other national
and international regulations) must be observed.
Failure to observe these regulations can lead to bodily injury, death
or considerable damage to property.
To Next Page
Loading...
Need help?
General
