EasyManuals Logo

Festo CMMS-ST-C8-7-G2 Assembly And Installation

Festo CMMS-ST-C8-7-G2
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
4. Functional safety engineering
Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH 97
A typical measurement curve could look as follows.
Graphically read brake time: 210 ms.
Fig. 4.9 Typical measurement curve for determining the brake time
4.3.13 Setting the delay time
The delay time of the PILZ PNOZ XV2P can be set manually at the device. This delay time
must be larger than the determined brake time. Otherwise, the drive would not brake in
the defined manner, but run out uncontrollably.

Table of Contents

Other manuals for Festo CMMS-ST-C8-7-G2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Festo CMMS-ST-C8-7-G2 and is the answer not in the manual?

Festo CMMS-ST-C8-7-G2 Specifications

General IconGeneral
BrandFesto
ModelCMMS-ST-C8-7-G2
CategoryController
LanguageEnglish

Related product manuals