2. Safety instructions for electric drives and controllers
22 Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH
2.4.6 Protection against touching hot components
Warning
DANGER!
Surfaces of the device housing may be hot!
Danger of injury! Danger of burning!
Warning
Danger of burning!
• Do not touch the surface of the housing in the vicinity of heat
sources.
• After switching devices off, leave them for 10 minutes to cool
down before touching them.
If you touch hot parts of the device such as the housing, which
contains the heat sink and resistors, you may burn yourself.
2.4.7 Protection when handling and assembling
Handling and assembling certain components in an unsuitable manner can cause injuries
under unfavourable circumstances.
Warning
DANGER!
Danger of injury as a result of incorrect handling!
Bodily injury caused by squeezing, shearing, cutting, impact!
The following safety measures apply here:
Warning
• Observe the general regulations on setting up and safety when
handling and mounting.
• Use suitable mounting and transport devices.
• Take suitable measures to prevent clamping and crushing.
• Use only suitable tools. If specified, use special tools.
• Use lifting devices and tools in a correct manner.
• If necessary, use suitable protective equipment (e.g. protective
glasses, safety shoes, safety gloves).
• Do not stand under hanging loads.
• Wipe up spilt liquids on the floor to avoid slipping.
To Next Page
Loading...
Need help?
General
