Festo CMMS-ST-C8-7-G2 Assembly And Installation

3. Product description
66 Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH
Note
The positions are saved on the SD card only through FCT. And so
when jog/teach (without FCT) is used, an SD card may not be
plugged in or “Read from SD after restart” must be inactive;
otherwise, when the controller is restarted, the old values will be
read off the SD card again.
Activating jog/teach function
The jog/teach function is started in I/O operation through selection of mode 1.

Festo CMMS-ST-C8-7-G2 Specifications

General

Brand	Festo
Model	CMMS-ST-C8-7-G2
Category	Controller
Language	English