1. Installation
1-6
Festo P.BE-CPX-FB32-EN en 1111a
Mounting Mount the fieldbus node as follows:
1. Place the fieldbus node in the interlocking block.
Make sure that the grooves with the power contact
terminals on the bottom of the fieldbus node lie above the
contact rails.
2. Push the field bus node carefully and without tilting into
the interlocking block up to the stop.
3. Only tighten the screws by hand. Place the screws so that
the self-cutting threads can be used.
4. Tighten the screws with a Torx screwdriver size T10 with
torque 0.9 ... 1.1 Nm.
To Next Page
