Commissioning
© Festo Didactic GmbH & Co. • MPS 25
Work out together with the participants the general steps of Installation.The
conditions for this example shall be:
• the PLC-board is removed
• no power supply connection, no air-pressure supply
• the Control Panel is removed
1. check the adjustment of mechanical components
2. check the adjustment of mechanical actuators holder
3. check the PLC-modules
4. assemble removed components (like PLC-board and Control Panel)
5. cable connections (PLC-board, Control Panel, communication)
6. connect all power supplies
7. check the adjustment of sensor holders
8. check the adjustment of sensors in the holders
9. check the adjustment of sensitivity of sensor
10. tubing connections
11. connect all air-pressure supplies (careful! turn pressure down before)
12. check the adjustment of the speed of pneumatic actuators
13. connect the stations together
14. check the mechanical position of hand over to the next station
15. communication connection
Planning
Please plan your activities within your team. Check first, which actuator could be
moved by hand and which not-use the technical documentation-pneumatic plan.
Check the inputs in the wiring diagram and at the PLC. Check the adjustment of the
sensors first, then the mechanical and pneumatical elements and.
The time to finish this project should be around 3,0 hour.
To Next Page
Loading...
