Components of the FT-100/CI and FT-170/CI 2-7
Document 40275-0913
2.5 Signal Beacon
2.5.1 Description
The beacon mounted on top of the operation station flashes when
a priority one system error occurs or a problem persists.
For example, if the FT-100/CI or FT-170/CI rejects one more case
than the maximum reject limit set by your plant management,
the beacon begins flashing and an error message appears on the
screen. The signal beacon assures that you are notified.
2.5.2 Steps: How to Stop a Flashing Beacon
Complete this step to stop a flashing beacon.
1. Highlight Clear Error and press Enter key on the control
panel.
Result: The beacon stops flashing and the message clears.
Note: If the error persists, contact your service department.
See also Steps: Verifying the Beacon
.
To Next Page
Loading...
