4-2 FT-100/CI and FT-170/CI Operation Guide
Document 40275-0913
4.1 Maintenance Checklist
4.1.1 Introduction
The following maintenance checklist recommends maintenance
tasks to keep the FT-100/CI or FT-170/CI at peak performance.
Depending on your company maintenance policy, you may need
to contact your service department to perform some of these
tasks.
4.1.2 Daily Maintenance
Perform these tasks daily.
Inspect all lenses and clean them if necessary.
Inspect all flap sensors and mountings to ensure that they are
tightened and the sensors are secured.
4.1.3 Weekly Maintenance
Perform these tasks weekly.
Clean and inspect the inspection head housing.
Inspect all external wiring and conduit for damage.
Verify that the beacon works properly.
Verify that the autoshutter is working correctly on the
FT-100/CI or verify the X-ray on/off switch is working
correctly on the FT-170/CI.
To Next Page
Loading...
