Operating the FT-100/CI and FT-170/CI 3-7
Document 40275-0913
3.5 Selecting the Case Type
3.5.1 Introduction
The Change Case Type menu enables you to select one of the
pre-programmed case type inspection routines that are installed
in your FT-100/CI or FT-170/CI. Each inspection routine applies to
a specific case type.
Select the number that applies to the case type that you are
inspecting and the FT-100/CI or FT-170/CI automatically recon-
figures its software parameters for the new case type. If the case
type that you are preparing to inspect is not programmed into the
FT-100/CI or FT-170/CI, contact your service department.
To help you remember which case type is assigned to which
number, a Case Type Form is included in this guide. On this form,
record the case type that is assigned to each number and keep
the list in a convenient location. The section Case Types List
contains more information about this form.
1. On the MASTER MENU, select Change Case Type.
Result: The FT-100/CI or FT-170/CI displays the Change
Case Type menu.
To Next Page
Loading...
