Filtec FT-170 - Changing the Case Type

3-6 FT-100/CI and FT-170/CI Operation Guide
Document 40275-0913
3.4 Changing the Case Type
3.4.1 Steps
Complete these steps to change the case type.
1. Select the appropriate case type from the Change Case
Type menu, as shown in Figure 3-3
.
You might also need to:
2. Adjust the height of the inspection beam, as described in
the section Adjusting the Height of the Inspection Beam
.
3. Adjust the conveyor guide rails, as described in the section
Adjusting the Guide Rails
.
4. Adjust the flap sensors if inspecting flaps, as described in
the section Adjusting the Flap Inspectors
.