4
CURRENT SET OF SAFETY DECALS
P/N 12278
BURN HAZARD!
Hot exhaust!
Stay back!
Failure to comply could result
in death or serious injury.
WARNING
P/N 31462
BURN HAZARD!
Cooling system is under pressure.
Allow system to cool before handling.
Remove radiator cap slowly.
Wear appropriate safety gear.
Failure to comply could result in death or serious injury.
RADIATOR HANDLING INSTRUCTIONS
1. Use a 50/50 solution of water and antifreeze. Using 100% antifreeze will result in engine damage.
2. Check and replenish water prior to use. More water will be consumed when operating in hot conditions.
3. If overflow pipe begins emitting vapor, check and replenish water.
4. Remove and clean screen when dirty.
5. Check and clean fins periodically. Clogged fins will increase water consumption.
6. Protect radiator from fertilizer corrosion by washing radiator core with water.
WARNING
P/N 31463
SEVER HAZARD!
Keep hands clear!
Rotating fan and gears.
DO NOT operate without guards or doors in place.
Shut off engine, disconnect battery, and allow all moving parts to
stop before servicing.
FLYING DEBRIS!
Wear eye protection around equipment.
Failure to comply could result in death or serious injury.
WARNING
P/N 31461
RUNAWAY VEHICLE HAZARD!
Always inspect tow vehicle and equipment hitch before towing.
Tighten all hitch bolts and properly connect wiring and safety chains.
BREAKAWAY SWITCH
DO NOT use for parking.
Attach cable to towing vehicle with enough slack for turning.
Engine battery on trailer must be charged and hooked-up for proper breakaway function.
SAFETY CHAIN INSTALLATION
Both the single and double chains must be crossed under tongue. They must be oriented in such a manner as to prevent
tongue from dropping to ground in event of failure to hitch, coupler or ball. Chains must be connected to towing vehicle so
slack for each length of chain, between trailer and towing vehicle, is the same and must have no more slack when in use than
necessary to permit proper turning of vehicles. Forward end of chain must be attached to towing vehicle, not to ball, but to
hitch or other frame member. Chain must be looped around member and hooked back into itself.
Failure to comply could result in death or serious injury.
WARNING
P/N 13184
Wear ear protection when
operating machine.
The sound power level could
exceed 80 dB(A) while the unit is in
operation.
Failure to comply could result in
moderate or minor injury.
CAUTION
P/N 31297
NEW CLUTCH INFORMATION
A new clutch may require several adjustments until
friction surfaces are worn in.
DO NOT let clutch slip. This will glaze and ruin
friction surfaces.
When properly adjusted a heavy pressure is required
at lever to move throwout linkage to “over center” or
locked position.
Always maintain proper adjustment.
Consult operations manual for adjustment
instructions.
Failure to comply may result in equipment damage.
CAUTION
To Next Page
Loading...
