21
RESET REGENERATION STANDBY DUE TO INHIBIT SWITCH
During machine operation with Regeneration in the Inhibit state on the control panel, a
notification and regeneration inhibited icon will display at the bottom of the screen. If the ECU
determines that Reset Regeneration is required, a Auto Regeneration request will be displayed.
If the operator allows the regeneration, it will begin and a notification and regeneration icon will
display at the bottom of the screen. If the operator delays the regeneration, the display will go to
dual mode with one display showing the regeneration inhibit icon and the regeneration request
continuously displayed at the bottom of the screen. Further, the Auto Regeneration request
message will re-display every 30 minutes. The machine can continue to operate with Reset
Regeneration inhibited for 3 hours, however, after 3 hours, a Stationary Regeneration request
may occur.
To Next Page
Loading...
