FISCHER DELTASCOPE DMP10 - Page 22

16
DMP10 / DMP20
Technical Data
Applications
Metrological Features
Measurement acquisition
 Default: After each placement of the probe onto the surface, a measured read-
ing is automatically recorded
Indication of measurement acquisition
 Audible by a short beep, can be disabled
 Visual by colored illuminated strip (green: measured value recorded)
 Limit violation: 2 short beeps, red illuminated strip and gauge vibration
 Measured reading between the limits: 1 short beep, green illuminated strip and
gauge vibration
Measurement performance
Measurement speed, measurement range, trueness etc. depend on connected
probe, you will find these data in the respective probe data sheet
Storage of measured readings
Can be disabled
Measurement unit
µm, mm, mils, µinch or customized unit (definable, related to µm), selectable
DELTASCOPE
DMP10
ISOSCOPE
DMP10
DUALSCOPE
DMP20
 
Base material electrically conductive (NF)
 Paint, varnish, plastic coating on
Al, Cu or Brass (NC/NF)
 Anodized coating on Al (NC/NF)
 
Examples
Base material steel or iron (FE)
 Zn, Cr, Cu coating on steel or iron
(NF/FE)
 Paint, varnish, plastic coating on
steel or iron (NC/FE)
Base material electrically conductive (NF)
 Paint, varnish, plastic coating on
Al, Cu or Brass (NC/NF)
 Anodized coating on Al (NC/NF)