53
DMP10 / DMP20
Calibration
9.5 Calling up information about the calibration
You can call up information for a selected calibration.
Before you start
The probe containing the calibration whose information you want to view is
connected to the gauge.
If the calibration whose information you want to call up is locked, you need to
know the lock code.
To call up information about a calibration
1. Select the calibration whose information you want to call up: > Calibrations >
OK > select name of the calibration > OK.
2. Prompted to set the lock code?
• Yes: Set the lock code:
• No: Continue with step 3.
3. Open the information page: Info > OK.
4. Exit the information page: .
Description of parameters on page Info
Only the standards, with their values, that were used for the calibration are displayed
on the information page next to the date and time.
Std 1 (NF/FE): 100 μm (example)
Calibration on ferrous base material (FE), indication of the foil thickness (nominal
value) for the Std. 1, used for this calibration.
Std 2 (NF/FE): 527 μm (example)
Calibration on ferrous base material (FE), indication of the foil thickness (nominal
value) for foil 2 used for this calibration.
Std 1 (NC/NF): 89.9 μm (example)
Calibration on non-magnetizable base material (NF), indication of the foil thickness
(nominal value) for foil 1 used for this calibration.
[ ]
To Next Page
Loading...
