FISCHER DELTASCOPE DMP10 - Signal Settings - Visual and Audible Signals; Energy Saving

75
DMP10 / DMP20 Gauge settings
13.3 Signal settings – visual and audible signals
You can activate and deactivate the sound and light signals for measured reading ac-
quisition and specification limit violations.
To activate/deactivate the signals
1. > Gauge Settings > OK > Signal Settings > OK
2. Select the desired signal function: > OK.
Function is activated:
• Parameter Light intensity, set the desired brightness value: > OK
The higher the set value, the higher the luminosity.
3. Repeat step 2. for more menu functions.
4. Exit the menu: , the settings are now made.
Signals
13.4 Energy saving
To prolong the battery life as far as possible, the gauge offers automatic shutdown
and display dimming as energy-saving functions.
Beeps/
beep
Visual signal
probe + gauge
Meaning
1 x short 1 x green Measured reading acquisition, measured
reading is within the specification limits/
above the specification limit when specifi-
cation limit monitoring is activated
1 x short + 1 x long 2 x red Measured reading is outside the specifica-
tion limits/below the specification limit
when specification limit monitoring is acti-
vated
[ ]