69
DMP10 / DMP20 Batch settings
12 Batch settings
For the batch, you can make settings that do not directly affect the measurement,
such as changing the Measurement view, the max. number of decimal places for the
displayed values or calling up the batch information.
12.1 Calling up information about the batch
You can call up information about the batch. All settings, assigned calibration and
probe information with which this batch works with are listed on an information
page.
To call up information about the batch
1. > Batch Modify > OK > Batch Info > OK
2. Exit the information page:
Description of parameters on page Batch Info
Batch Name
Name of the batch file.
Probe Name
Name of the probe with which this batch works.
Probe Serial Number
Serial number of the probe with which this batch works.
Calibration
Name of the calibration assigned to this batch.
Limits [µm]
Information on specification limit monitoring: off or indication of the specification
limits (LSL and USL)/ the specification limit (LSL).
Measurement View
Type of Measurement view set for this batch (Simple, Statistics).
[ ]
To Next Page
Loading...
