Fisher & Paykel DCS RGS Series - Page 30

29
5. To remove the grill burner ignitor:
a) Remove the burner (see step 4).
b) Remove the two screws and nuts from the ig-
nitor bracket and remove the ignitor.
d) Remove the two front grill screws.
Grill Burner Ignitor Screws & Nuts
c) Pry up the left end of the front trim and remove
the trim.
Pry Up End Of Front Trim
2 Front Grill Screws
e) Lift the grill box out of the range and set it on a
padded surface to protect the fi nish.
f) Disconnect the white ignitor wire from the single
thermal valve terminal.
g) Twist the ceramic nut from the end of the wires,
untwist the wires, and remove the ignitor wire
and ignitor.
Thermal Valve White Wire Ceramic Nut
Ignitor
SERVICING THE COMPONENTS
REMOVING THE GRILL BURNER & IGNITOR
Front Trim