Fisher & Paykel DCS RGS Series - Removing the Grill Burner & Ignitor

28
3. Lift the front of the radiant tray and remove it from over
the grill.
1. Turn off the gas and disconnect power to the range.
2. Remove the two grates from the top of the grill.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
Grill Grates
4. To remove the burner from the grill:
a) Remove the screw from the rear burner brack-
et.
Radiant Tray
Grill Burner Rear Screw
b) Lift the rear of the burner and pull the air shutter
off the orifi ce on the single thermal valve.
Orifi ce Air Shutter
SERVICING THE COMPONENTS
REMOVING THE GRILL BURNER & IGNITOR
WARNING