36
1. Turn off the gas and disconnect power to the range.
2. Loosen, do not remove, the two false handle screws,
and allow the handle to drop down as far as it will go.
Transformer Reignition Module
False Handle Screws
4. To remove the transformer:
a) Remove the two nuts from the screws and re-
move the two screws from the transformer.
b) Remove the ceramic nuts from the wires, sepa-
rate the wires, and remove the transformer pri-
mary and secondary wires.
c) Remove the nut from the ground screw and
remove the white transformer wire.
3. Remove the valve panel (see page 56 for the proce-
dure).
Nut & Screw 3 Ceramic Nuts Nut & Screw
Ground Wires
Transformer
SERVICING THE COMPONENTS
REMOVING THE TRANSFORMER & REIGNITION MODULE
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
WARNING
To Next Page
Loading...
