Fisher & Paykel DCS RGS Series - Removing the Main Oven Bake Burner & Ignitor

50
6. Lift the front of the oven fl oor and slide it out of the
oven.
7. To remove the main oven bake burner:
a) Remove the screw from the rear of the burner.
1. Turn off the gas and disconnect power to the range.
2. Remove the main oven door (see page 78 for the pro-
cedure).
3. Remove the racks from the oven.
4. Remove the side rack supports.
5. Remove the two screws from the left and right lower
front rack brackets and remove the brackets.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
Side Rack Supports
Lower Front Rack Brackets
b) Lift the rear of the burner, pull the air shutter at
the front of the burner off the orifi ce, and remove
the burner.
Rear Burner Screw
Oven Floor
SERVICING THE COMPONENTS
REMOVING THE MAIN OVEN BAKE BURNER & IGNITOR
Burner Air Shutter
Orifi ce
WARNING