49
8. Loosen the two Allen setscrews on the convection blade
and remove the blade.
10. Cut the wire tie from around the motor wires.
NOTE: When reassembling, use a new wire tie.
11. Remove the four locknuts and remove the motor from
the bracket.
9. Remove the four hex-head screws from the convection
motor bracket and remove the motor and bracket from
the assembly.
Fan Blade Setscrews
Convection Motor Screws (2 of 4)
Motor Bracket Locknuts (1 of 4)
Wire Tie
Convection Motor
SERVICING THE COMPONENTS
REMOVING THE CONVECTION MOTOR
To Next Page
Loading...
