51
8. To remove the main oven bake burner ignitor:
a) Remove the two screws from the kick panel, then
pull the top of the panel forward, slide the two
nylon tabs from their catches, and remove the
panel.
b) Remove the two ceramic nuts from the wires
and remove the main oven bake burner ignitor
Kick Panel
Screw
Screw
Catches
Tabs
c) Remove the two screws and nuts from the bake
burner ignitor and remove the ignitor.
Burner Ignitor
Burner Ignitor Wires
Burner Ignitor Screw & Nut
REASSEMBLY NOTE: When you reinstall the oven
fl oor, do not install the two air adjustment clips
over the front fl ange of the oven fl oor. The clips are
installed below the fl ange, as shown below.
Air Adjustment Clips
Correct Clip Position
Oven Floor Flange
Incorrect Clip Position
SERVICING THE COMPONENTS
REMOVING THE MAIN OVEN BAKE BURNER & IGNITOR
To Next Page
Loading...
