Fisher & Paykel DCS RGS Series - Page 38

37
5. To remove the reignition module:
a) Pull the primary wiring connector off the reigni-
tion module.
b) Remove the two screws from the reignition mod-
ule and pull the module out as far as possible.
c) Note the wire locations, and then disconnect
the burner wires from the reignition module
and remove the module.
Screw
Reignition Module
Screw
Primary Wire Connector
Burner Wires
SERVICING THE COMPONENTS
REMOVING THE TRANSFORMER & REIGNITION MODULE