56
• Remove control panel as per instruction 8.8.
• To remove the temperature display, remove the
knob and remove the plastic light pipe halo by
rotating it anti clockwise to undo, you may need
to use long nose pliers.
• The selector encoder will now pull out of the back
of the temperature module.
• Remove the user interface harness at the
temperature module.
• To remove the temperature module, release the
two clips along the top, and pull the module
forward to release from the panel.
8.10 Removal of the Function Module
•
Remove the control panel as per instruction 8.8
• To remove the function PCB, remove the knob and
remove the plastic light pipe halo by rotating it anti
clockwise, you may need to use long nose pliers.
• The selector encoder will not release out the back of
the function PCB.
• Remove the user interface harness from the
function module.
• Using a at blade screwdriver, gently release the top
clips on the module and pull forward to release it
from the panel.
Clip
To Next Page
Loading...
Need help?
General
