57
8.11 Removal of the Clock module
•
Remove the control panel as per instruction 8.8
• Remove the user interface harnesses from the
clock module.
• Depress the small clip on the bracket and slide it
to the right to release.
• The clock module will now release from the
retainer. Lift the bottom of the PCB outwards
and it will release from the upper clips.
• If the module is replaced, you will need to
ensure the correct model ID is set for the
product you are working on, refer section 6,
pages 37 & 38.
Clip
Slide
8.12 Removal of the Door Switch
•
Remove the control panel as per instruction 8.8.
• Remove the door switch by depressing the small
tab on the top of the bracket.
• The switch will rotate to release from the panel
• Reassemble in reverse order, and make sure the
harness is connected to the PCB.
• Check the magnet is correctly located in the door
cap to ensure correct operation. (refer to section
8.1)
To Next Page
Loading...
Need help?
General
